Model: Legend Series II     

RECREATIONAL VEHICLE INVERTER / CHARGER

Designed Specifically for recreational vehicles
The Trace Legend Series II has set a new industry standard for performance, advanced features and user friendly operation. Flexible enough to meet the most sophisticated users needs and yet so simple to operate - set it and forget it. There are no dip switches or jumpers to set. All features are accessible via a menu driven remote display. Permanent memory stores your menu selections even if power is disconnected. It never needs reprogramming unless your power needs change.

High performance, high surge inverter power, three stage battery charger with temperature compensation, automatic shore power black-out protection, full feature remote controls with meters and battery fuel gauge.

Standard Features:

• 2k, 2.5k, and 3kva models offer the most power of any RV inverter.
• Adjustable battery charging from 10 amps DC to full rated charger output. (100, 120 or 140 amps).
• 3 stage battery charging with Temperature Compensation for optimum battery care.
• Dead battery recharging.
• Automatic battery charger back-off prevents shore power breaker tripping.
• Automatic 30 amp transfer switch for transparent switch-over between battery and shore power or generator.
• Selections for flooded or sealed (Gel Cel) battery charging.
• Selection for deep or shallow cycle battery discharge protection.
• Automatic neutral / ground switching for UL and NEC compliance.
• Automatic shore power black-out protection.

Optional Remote Controls:

• RC6
  • Simple LED bar-graph displays DC voltage and current levels.
  • Inverter On/Off control.
  • Inverter/Charger status LEDs.
• RC7
  • Simple menu driven programming for full control of all inverter/charger features.
  • Three-level menu prevents accidental setting changes.
  • Built-in meters display DC voltage, DC current, AC voltage and AC current.
  • RJ11 phone jack connection to inverter.
  • Built-in memory retains menu settings even with a loss of power.
  • Intelligent built-in battery fuel gauge reports % of battery charge or time left to run read-out.

Specifications:

	L2012	L2512	L3012
Continuous Output Power @ 25C	2000VA	2500VA	3000VA
Continuous AC Output Current @ 25C	16.6 amps	20.8 amps	25 amps
Efficiency (peak)	94%	94%	94%
DC Requirements:
Normal Input Voltage	12VDC	12VDC	12VDC
Input DC Voltage Range	10.2 - 15.5 VDC	10.2 - 15.5 VDC	10.2 - 15.5 VDC
Search mode	0.055 amps	0.070 amps	0.080 amps
On Mode (no load - idle)	0.55 amps (6.3 watts)	0.60 amps (7.2 watts)	0.650 amps (7.9 watts)
At Full Rated Power	200 amps	250 amps	300 amps
Short Circuit Output	600 amps	800 amps	900 amps
Automatic Low Battery Protection	10.9 VDC or defeated	10.9 VDC or defeated	10.9 VDC or defeated
Adjustable Battery Charge Rate	10-100 amps	10-120 amps	10-140 amps
Minimum Recommended DC    Fuse Size	300 amps DC	300 amps DC	400 amps DC
Minimum Recommended DC    Cabling	#4/0 AWG	#4/0 AWG	#4/0 AWG
AC Output Characteristics
Voltage Regulation - Max.	+/- 5%
Voltage Regulation - Typical	+/- 2.5%
Output Waveform	modified sine wave
Power Factor Allowed	0 to +1
Frequency Regulation	60 Hz +/- .04%
Standard Output Voltage	120 VAC RMS
Adjustable AC Load Sensing	5 to 40 Watts AC
Automatic Transfer Relay	30 amps AC at 120 VAC
Battery Charger Characteristics
Charging Profiles	Vented lead acid or sealed lead acid (Gel Cel)
Charging Process	Three stage charging process (Bulk, Absorption, & Float)
Battery Temperature Compensation	with optional BTS sensor
Options
Remote Control	RC6: Simple LED Bargraph DC voltage / ammeter with ON/OFF switch RC7: Full function remote control with LCD display and status LEDs.
Battery Temperature Sensor (BTS)	BTS Sensor with 15 or 35 foot cable (plug in)
DC Fuse Block (TFB)	Class T fuse with holder and protective cover - 300 amp, 400 amp sizes.
Environmental
Forced Air Cooling	Variable speed brushless DC fan.
Specified Temp. Range	32F to +100F (0C to +40C) (will meet specified tolerances)
Allowed Temp. Range	-40F to +140F (-40C to +60C) (may not meet specified tolerances)
Non-operating Temp. Compensation	-67F to +167F (-55C to +75C)
Enclosure Type	Indoor, ventilated, steel chassis with powdercoated finish.
Dimensions - inverter only	13.125" x 7.25" x 15.50"
Mounting	Shelf mount Only
Unit Weight	45 lbs. (20.5kg)	50 lbs (22.7kg)	60 lbs (27.2kg)
NOTE: All specifications are subject to change without notice. Adjustments required RC7 Remote Control.

Power VS Time charge for Legend Series II	Charging Profile
Legend Series II Efficiency Chart